Skip to main content
Skip table of contents

Reset on Intent Change

The Reset on Intent change flag allows re-asking a piece of information if the caller provides a second intent. If the feature is enabled, all the data previously contained in outputs is erased, and, since the conversation continues from the selected miniApp, is substituted by the data containing new intent from a caller.

Reset on Intent change applies to the whole application and resets outputs for all the blocks that have Reset on Intent change enabled.

The Reset on Intent Change can only be applicable in the Intent miniApp if the Anything Else? building block has already been used.

To enable the feature, follow the steps:

  1. Select the miniApp that you want to be repeated if the caller’s intent changes and click the Settings button in the right upper corner of the miniApp to configure.

  2. Check the Reset on Intent change box to enable the feature.


JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.